Thursday, January 26, 2017

Port-powered Isolation RS232 to RS485 Converter

Port-powered Isolation RS232 to RS485 Converter



The SW485WA is an industrial grade bi-directional port-powered 2500V opto-isolated RS232 to RS485 converter in a 9 pin format. It can convert any standard full duplex RS232C port to any two-wire balanced half duplex RS485 port. In simple terms, it will convert any RS232 signal to a RS485 signal and vice versa. The unit is powered from the RS232 data lines. It also supports data direction auto-turnaround. Therefore, no external power or flow control is required. The data direction auto-turnaround automatically enables the RS485 driver when data is present on the RS232 side making the device plug-and-play, requiring no software drivers. The SW485WA has a DB9 female connector on the RS232 side and either a DB9 male connector or 3 bit terminal block on the RS485 side.


    Features
    1. Optical isolation effectively protects RS-232/RS-485 devices from transient surges, ground loop, and remote lightning
    2. Plug-and-Play (Device is hot-pluggable, Data format Auto-sensing & Self-adjusting)
    3. Maximum baud rate 38400bps, 1200m(9600bps)
    4. Port-powered, no external power or TXD, RTS, DTR required
    5. Data direction auto-turnaround, no flow control is required
    6. 2500V isolation, no power supply needed

    Specification
    Standards: EIA RS-232C, RS-485 standard
    RS-232 signal: TX, RX, GND
    RS-485 signal: D+, D-, GND
    Working mode: Asynchronism, point to point or multi point, 2 wire half-duplex
    Baud rate: 300~115200bps, auto test serial signal rate detect signal speed automatically, zero delay time
    Flow control: Data direction auto-turnaround, no flow control is required
    Transfer distance: RS-485 side: 1.2Km, 9600bps
    RS-232 side: no less than 5m
    Max number of drops: 128 nodes
    Optical isolation: 2500V
    Port protect: 1500W surge protection, 15KV ESD protection
    Connector: RS-232 side DB9 female
                     RS-485 side DB9M( DB9F to 3 bit terminal block)
    PowerPower input: No power supply need, powered from TXD, RTS,DTR
    Consumption: Static less than 10mA, dynamic less than 40mA
    Environment
    Operating temperature: -40°C to 80°C
    Storage temperature: -40°C to 85°C
    Humidity: 5% to 95%(no condensation)
    Appearance
    Dimensions: 95.0mm×33.0mm×16.5mm     
    Material: Plastic(shell) 

No comments:

Post a Comment